What a quantum mechanics viva tests

A quantum mechanics viva is a conversation in which you explain ideas aloud and respond to follow-up questions. The exact format depends on your course, institution and examiner; there is no single international format. Check your course handbook or department guidance for the topics, assessment arrangements and any formal criteria that apply to you.

The questions below are practice stations, not a prediction of a particular institution’s viva. They focus on three connected skills: stating the mathematical result correctly, explaining what it means physically, and identifying the assumptions behind it. A correct equation without interpretation can leave an answer unfinished. A confident explanation with a wrong boundary condition or factor of two is still wrong.

For each station, practise a short opening answer, then handle one or two follow-ups. A useful sequence is:

  1. Define the system. State the potential, state or measurement you are discussing.
  2. Give the governing relation. Write or say the relevant equation, with symbols defined.
  3. Explain the result. Connect the equation to a physical prediction.
  4. Name a limit or assumption. Say what the model leaves out, or what would change the answer.

This sequence keeps an answer organised without turning it into a memorised speech. If you need a moment, restate the question in your own words and say which part you will answer first. If you do not know a result, explain what you can establish and where your reasoning stops rather than guessing.

Set up the practice viva

A useful practice examiner should probe explanation, not reward a rehearsed paragraph. In the practice strip below, the emphases are study prompts, not an official marking scheme. MySummaries can use an examiner persona to keep follow-up questions focused on the subject you are practising.

The examiner strip for this set looks like this:

ExaminerQuantum Mechanics viva practice
Conceptual accuracyMathematical reasoningPhysical interpretationAssumptions and limits
Illustrative practice examiner strip for a quantum mechanics viva.

Build stations from topics you can explain on a board or piece of paper, not just recognise in notes. The four prompts below move from a solvable model to measurement and then to a standard bound-state system. Use the opening question as your first spoken answer; let a partner or recording ask the follow-ups.

The station list gives each topic a distinct starting point:

StationAttemptsBestAvg
Particle in an infinite wellFor a particle confined to 0 < x < L by infinite walls, derive the allowed energies and interpret the ground state.27468
Spin measurementA spin-1/2 particle is prepared in the +x state and measured along z. What outcomes and probabilities do you expect, and what happens after the measurement?17871
Quantum harmonic oscillatorExplain why the one-dimensional harmonic oscillator has a non-zero ground-state energy, and give its energy levels.0——
Barrier penetrationFor a particle with energy E below a rectangular barrier of height V₀, explain what the wavefunction does inside the barrier and how transmission depends on barrier width.0——
Illustrative set of four quantum mechanics oral-practice stations and their attempts.

Station 1: particle in an infinite well

This station checks whether you can apply boundary conditions rather than merely quote an energy formula. Start by defining the well: the potential is zero for 0 < x < L and infinite outside. The wavefunction must vanish at the walls, so the allowed interior solutions are standing waves. Explain the connection between the boundary conditions and the integer quantum number before giving the energy levels.

A common follow-up is why the lowest energy is not zero. A zero-energy particle would have zero wave number in this model, giving a constant wavefunction in the well. That cannot satisfy both zero boundary values unless the wavefunction is zero everywhere, which is not a physical normalised state. The non-zero ground-state energy is also consistent with confinement and the uncertainty principle, though the boundary-condition argument is the direct derivation here.

The practice answer below earns most of its credit by linking the boundary conditions to the allowed values of the wave number. It loses some because it could explain the invalid zero-energy solution more precisely. The feedback criteria are practice criteria, not universal viva rules.

A worked answer to the infinite-well station looks like this:

Oral — Particle in an infinite wellMarked

Examiner

For a particle confined to 0 < x < L by infinite walls, derive the allowed energies and interpret the ground state.

2:143:00Mark answer
76%Particle in an infinite well — marked76/100 · Developing · 2:14 spoken of 3:00
Sets up the potential and boundary conditions18/20

Identifies the zero potential inside and zero wavefunction at both walls.

ImproveState explicitly that the wavefunction vanishes at x = 0 and x = L.

Derives the allowed states and energies17/20

Connects the standing-wave condition to integer n and gives the energy spectrum.

ImproveDefine n as a positive integer and show how k = nπ/L enters the energy.

Interprets the ground state13/20

Recognises that the ground energy is non-zero but does not fully explain why n = 0 is invalid.

ImproveExplain that n = 0 would give only the zero, non-normalisable physical state under these boundary conditions.

Explains the model's scope14/20

Mentions idealised walls but does not distinguish the model from a finite-well potential.

ImproveSay that real confining potentials are finite and can permit wavefunction penetration beyond the well.

A strong answerInside the well the potential is zero, so the time-independent Schrödinger equation gives sinusoidal solutions. The infinite walls require ψ(0) = ψ(L) = 0, which allows k = nπ/L for positive integers n. Therefore ψₙ(x) = √(2/L) sin(nπx/L) inside the well and Eₙ = n²π²ℏ²/(2mL²). The ground state has n = 1, so its energy is non-zero; n = 0 would give a zero wavefunction rather than a normalised state. This is an idealisation: a finite well has tails outside the classically allowed region.

Illustrative marked practice answer on the infinite square well.

That is a MySummaries station, filled with quantum mechanics material. Yours is written from your own notes. Start free

To improve this answer, practise deriving the result on a blank page in under a minute, then explain each line without looking. Do not skip the word “positive” when specifying n. The formal solution with n = 0 is not a separate physical ground state: it gives no probability density at all. If asked about a finite well, distinguish it from the infinite-well result rather than claiming the same wavefunctions apply everywhere.

Station 2: spin measurement

This station tests whether you distinguish a state from the result of a measurement. For spin one-half, a measurement of the spin component along z returns +ℏ/2 or −ℏ/2. In the z basis, the +x state is an equal superposition of those two z states. The probabilities come from the squared magnitudes of the coefficients, not from treating the superposition as a hidden choice of one result.

A likely follow-up asks what happens if the apparatus measures z again, or measures x after obtaining +z. An ideal repeat measurement of z gives +ℏ/2 with certainty after a +z result. But +z is an equal superposition of +x and −x, so a subsequent ideal x measurement gives either result with probability one half. State the measurement direction each time; otherwise it is easy to confuse the state labels.

The answer below is strong on probabilities and sequential measurements. It could be more explicit that the state update described assumes an ideal projective measurement.

A worked answer to the spin station looks like this:

Oral — Spin measurementMarked

Examiner

A spin-1/2 particle is prepared in the +x state and measured along z. What outcomes and probabilities do you expect, and what happens after the measurement?

2:313:00Mark answer
81%Spin measurement — marked81/100 · Strong with one qualification · 2:31 spoken of 3:00
Identifies the possible z outcomes19/20

Gives +ℏ/2 and −ℏ/2 as the possible measured values.

ImproveKeep the measured component explicit: these are z-component outcomes.

Calculates outcome probabilities18/20

Uses the equal amplitudes of the +x state in the z basis to obtain equal probabilities.

ImproveShow that the probabilities are squared amplitudes, each 1/2.

Describes the post-measurement state16/20

Says the state becomes the observed z eigenstate but leaves the measurement assumption implicit.

ImproveQualify this as an ideal projective measurement.

Handles a sequential measurement15/20

Correctly predicts a repeat z result but could connect a later x measurement to the basis change.

ImproveState that measuring x next gives equal probabilities from either z eigenstate.

A strong answerFor spin one-half, an ideal z measurement can return +ℏ/2 or −ℏ/2. The +x state is (|+z⟩ + |−z⟩)/√2, so the squared amplitude for each z outcome is 1/2. After an ideal measurement yielding +ℏ/2, the state is |+z⟩, and an immediate repeat z measurement returns the same value with certainty. If I then measure x, |+z⟩ has equal squared amplitudes in the x basis, so either x outcome has probability 1/2. The outcome is probabilistic, but the probabilities follow from the prepared state and the measurement basis.

Illustrative marked practice answer on spin and sequential measurements.

When practising, say the state in the basis relevant to the measurement before stating probabilities. If you only say “it is a superposition”, the examiner cannot tell whether you can calculate the outcomes. If asked whether the particle “really had” one of the z values before measurement, answer carefully: the formalism predicts the measurement probabilities for the prepared state; do not replace that prediction with an unsupported classical picture.

Station 3: quantum harmonic oscillator

The oscillator is a useful viva topic because one compact result connects the Hamiltonian, quantised energy and zero-point motion. For a particle of mass m in a one-dimensional quadratic potential, the Hamiltonian is p²/(2m) + mω²x²/2. Its energy eigenvalues are ℏω(n + 1/2), where n is a non-negative integer. The ground state therefore has energy ℏω/2.

If asked why the ground-state energy cannot be zero, explain that the oscillator’s ground state cannot have both zero position uncertainty and zero momentum uncertainty. A state exactly at the potential minimum with zero momentum would conflict with the uncertainty relation ΔxΔp ≥ ℏ/2. Be precise: the uncertainty principle helps explain the non-zero ground energy, but the spectrum follows from solving the quantum oscillator problem. Avoid saying the particle follows a classical trajectory at the ground energy.

The answer below correctly gives the spectrum and the uncertainty argument. Its remaining improvement is to distinguish that physical explanation from a derivation of the exact spectrum.

A worked answer to the oscillator station looks like this:

Oral — Quantum harmonic oscillatorMarked

Examiner

Explain why the one-dimensional harmonic oscillator has a non-zero ground-state energy, and give its energy levels.

2:063:00Mark answer
74%Quantum harmonic oscillator — marked74/100 · Sound core answer; expand the derivation · 2:06 spoken of 3:00
States the Hamiltonian and spectrum17/20

Gives the quadratic Hamiltonian and the correct levels ℏω(n + 1/2).

ImproveDefine n = 0, 1, 2, … and identify ω as the oscillator angular frequency.

Explains the non-zero ground energy15/20

Connects confinement to uncertainty but gives little detail about simultaneous position and momentum localisation.

ImproveExplain why a state concentrated at the potential minimum cannot also have zero momentum uncertainty.

Distinguishes interpretation from derivation12/20

Uses the uncertainty principle as if it alone derived the exact spectrum.

ImproveSay that the exact levels come from solving the quantum Hamiltonian; uncertainty gives physical intuition for a non-zero minimum.

Interprets the ground state physically15/20

Recognises non-zero energy but does not clarify that the ground state is not a classical orbit.

ImproveDescribe it as a stationary quantum state with non-zero energy, not a particle tracing a classical path.

A strong answerThe one-dimensional oscillator has Hamiltonian H = p²/(2m) + mω²x²/2. Its allowed energies are Eₙ = ℏω(n + 1/2), with n = 0, 1, 2, …, so the ground-state energy is ℏω/2. It is not possible to make both position and momentum uncertainties vanish, as ΔxΔp ≥ ℏ/2. That gives physical intuition for why a confined ground state cannot have zero energy. The exact spectrum comes from solving the quantum oscillator Hamiltonian, and the ground state is not a classical orbit.

Illustrative marked practice answer on the quantum harmonic oscillator.

Review the words that lose marks

Listening to a recording can reveal vague phrases that feel adequate while you are speaking. “The wavefunction collapses” is not a complete explanation if the question asks for probabilities or the state after measurement. “It has a minimum energy” needs the value and the reason the minimum is not zero. Replace broad claims with a named state, an equation or a stated assumption.

The transcript below shows one answer that is mostly clear but loses detail at two points. Read the replacement phrase aloud, then record the answer again and see whether you can add the missing precision without making it longer.

A marked phrase from the spin answer looks like this:

Transcript

The +x state is an equal superposition in the z basis, so the two z outcomes have equal probability. After the measurement the state collapses. If you measure z again, you get the same result. The result tells us what the particle had all along.

not enough detail
After the measurement the state collapses.

This names a process but does not say which state follows a particular result or which measurement model is assumed.

Say: After an ideal z measurement yielding +ℏ/2, the state is |+z⟩; an immediate repeat z measurement returns +ℏ/2 with certainty.
Illustrative transcript feedback highlighting a vague measurement explanation.

The second marked sentence makes a claim that does not follow from the measurement probabilities. A stronger answer describes the prepared state, the chosen measurement and the predicted result. You can be precise without taking a position on interpretations that the question has not asked you to discuss.

A repeatable weekly routine

Use a short cycle for each topic:

  • Prepare: choose one question from your notes and sketch its equations, definitions and assumptions.
  • Answer aloud: give a two- or three-minute response without reading. Keep the opening direct: define the system and state the result you will explain.
  • Take follow-ups: ask “why?”, “what changes if…?” and “what assumption did you make?” Use a partner, voice recorder or practice examiner.
  • Review: note one correct point, one missing step and one sentence to make more precise. Then answer the station again.

Rotate topics rather than repeating a single comfortable one. For example, alternate a boundary-value problem, a measurement question and a dynamics or approximation question. Keep an error log of specific corrections: “state n is a positive integer” is actionable; “revise the well” is not. Revisit the error after a delay, because recognising the corrected answer immediately is easier than producing it unaided later.

Do not treat a practice score as a prediction of a course result. The useful output is the exact gap to work on: an omitted boundary condition, a probability not squared from its amplitude, or an interpretation stated as though it were a derivation. If your course publishes a viva rubric, use that rubric for formal preparation and check your lecturer’s notation conventions.

How MySummaries helps

MySummaries lets you build a revision board from your own quantum mechanics notes, then practise viva stations generated from that material. Its recorded oral practice can return feedback on the answer and point you back to the concept to review; use this alongside, not instead of, your course’s guidance. Start at portal.mysummaries.app.